unikite-wings
custom wings for all who love the wind
Namely, elimination of a number of technical shortcomings that exist in other manufacturers. And so, without loss of quality, reduce the final cost of the wing and make sailing more accessible for all lovers of wind.
For increased reliability of the wing as a whole and for greater ease of installation of the wing, some nodes have been upgraded device.
In developing wing Unikite, our main task was upgrading the wing.
PICTURE 1
PICTURE 2
Mast, made of fiberglass and carbon fiber, are often broken in the fall at fixing rivets picture № 1 have been replaced by a special aluminum alloy AL2024, which is composed of titanium. Which is used in the aerospace industry. picture № 2
Failure to use a brittle material allowed to make wing resistant to falls and more reliable with the weight of the wing is not significantly increased.
In case of broken masts, replacement masts alloy AL2024 cost much cheaper.
PICTURE 3
PICTURE 4
Side lats wings of other manufacturers this is semicircular thin twig fiberglass section 10mm * 6mm. picture № 3
Such thin and fragile armor break at the moment of falling is very common, especially during first training, piloting wing.
Wing Unikite, side lats made of composite pipes, reinforced fiberglass inside diameter of 25 mm.
This allowed to fully recover from damage side lats. picture № 4
Each windsurfer knows that the film of the sail, should not deform.
Otherwise, the sail quickly privratilas in a rag.
Application of lightning on each side of the wing Unikite, helped gather the wing is much faster and more comfortable, especially in a strong wind. picture № 4
At the same time, the film sails in good condition much longer.
PICTURE 6
The second of innovations, simplifying the assembly of the wing sail and keeps the film is demountable mast.
Due to this modernization, the sail is not necessary to keep into the hand at the time of assembly,picture № 5 and putting the sail on the floor, in turn, quickly insert the mast are connected by them to each other. picture № 6 end picture № 2
PICTURE 5
PICTURE 6
The same has been increased strength of the entire carcass as a whole, due to the replacement of the alloy used in the furniture manufacturing AL60-63 picture № 7 on extra strong alloy, with a content of titanium used in the aerospace industry AL2024 and AL T6 7075 picture № 8
PICTURE 7
